Whole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Before
After
Before
After
Before
AfterAbatement Technologies Air Duct Cleaning in Austin: What to Know First
CleanRun Duct Repair & Cleaning provides independent Abatement Technologies air duct cleaning in Austin, with most residential jobs completed in a single scheduled visit and every customer receiving a written price before we remove the first access panel. Typical whole-system cleaning for Abatement Technologies setups in Austin runs $380-$680 for homes under 3,500 square feet, with commercial systems starting around $1,200 depending on plenum complexity. We’re not affiliated with Abatement Technologies - we operate as an independent service provider - which means our recommendations are based on what the camera shows, not on manufacturer protocols that may not fit your specific installation. Call (737) 243-9544 for a free estimate with a written price delivered on the spot.
How Abatement Technologies Products Fail - and How We Fix Them
- PREDATOR 750 Series negative air machines: The HEPA filter housing seals degrade faster in Austin’s combination of high summer heat and caliche dust infiltration. We’ve opened units where the gasket compression had failed enough to let unfiltered return air bypass the filtration stage entirely. We replace with OEM-spec silicone gaskets and document the seal test with before-and-after pressure readings.
- BD2K bedbug dryers and associated ducting: The high-temp flex runs on these systems sag in Austin’s attic installations where daytime temperatures exceed 140°F. The sag creates low-velocity zones where lint and insect debris collect, eventually restricting airflow enough to trigger thermal cutoff faults. We reroute with supported hard duct where possible and photograph every joint.
- Abatement Technologies portable air scrubbers (PAS series): The pre-filter frames warp slightly after repeated filter changes, creating bypass gaps that owners rarely notice. During cleaning, we check frame squareness with a straightedge and replace distorted frames rather than forcing filters to seat - a shortcut that costs filtration efficiency.
- HEPA-CARE ceiling-mounted filtration: The plenum connections on these units in Austin’s newer construction (2015-2022 builds in Mueller, East Austin, and Circle C) often use snap-lock duct that loosens from thermal cycling. We find separated connections that appear intact until the camera goes in. Our fix: mechanical fastening plus mastic seal, documented with photo.
- Abatement Technologies HEPA-AIRE duct cleaning system components: The vacuum hose cuffs wear at the collar attachment points from the abrasive debris loads in older Austin homes - particularly pre-1980s Tarrytown and Clarksville builds with original galvanized duct. We inspect cuffs for internal delamination and replace before they shed synthetic fragments into the airstream.
Our Abatement Technologies Air Duct Cleaning Process
- 1
Camera scope before quote: Tomas Reyes or a senior tech inserts a borescope through the main trunk access to show you what’s in the plenum before we name a price. No verbal estimates built on square footage alone.
- 2
Written price under Haven Standard Clause 1: You get a single flat price for the whole system, itemized by duct run count, before any panel comes off. Per-vent pricing does not exist in our process.
- 3
Negative-pressure extraction with Abatement Technologies-compatible equipment: We match our Rotobrush and Nikro vacuum systems to your Abatement Technologies duct specifications - flex, hard pipe, or hybrid - and adjust brush aggression to the debris type the camera revealed.
- 4
OEM or verified-equivalent parts only: Filter housings, gaskets, and connection hardware are sourced to Abatement Technologies tolerances or documented cross-referenced equivalents. We note the part origin on your job record.
- 5
Post-clean verification and photo record: Every duct run is photographed after cleaning. You receive the complete image set as a standard deliverable, not an upsell. The 365-Day Done Right Promise applies from this point.
- 6
System airflow test: We verify static pressure and register velocity against the manufacturer’s rated range for your Abatement Technologies equipment, with readings written on the final invoice.
BeforeAfterWhat Abatement Technologies Air Duct Cleaning Costs in Austin
| Service | Typical Range | What Moves the Price |
|---|---|---|
| Residential whole-system cleaning, Abatement Technologies setup | $380-$680 | Duct run count, attic vs. crawlspace access, presence of HEPA-CARE or PAS integrated filtration |
| Commercial negative air / HEPA system cleaning | $1,200-$2,400 | Plenum size, filter bank count, after-hours scheduling requirements |
| Abatement Technologies bedbug dryer duct cleaning (BD2K series) | $290-$520 | Flex run length, hard-duct conversion needed, debris type (lint vs. insect matter) |
| HEPA filter housing seal replacement | $180-$340 | Gasket material (standard silicone vs. high-temp spec), housing count |
Three factors push Abatement Technologies jobs toward the higher end in Austin: integrated HEPA filtration that requires disassembly for proper duct access, attic installations where caliche dust has compounded normal household debris, and older Hyde Park or Clarksville homes where original duct sizing doesn’t match current equipment airflow demands. We state which factors apply to your job before you decide. Call (737) 243-9544 - estimates are free, and the price we write is the price you pay.
Why Austin Homeowners Call CleanRun Duct Repair & Cleaning for Abatement Technologies Work
We’ve cleaned Abatement Technologies systems in Austin since 2013, and we’ve learned that owners of this equipment tend to be detail-oriented - they’ve already read the manual, they know the model number, and they want a technician who doesn’t need the basics explained. Tomas Reyes, our owner, came up through Bronx Community College’s HVAC program and spent years in commercial ductwork before relocating to Austin; he’s pulled cameras through original flex duct in Hyde Park bungalows that hadn’t been opened since 1993. Our crew also services Lennox, Trane, and Carrier systems, which matters when your Abatement Technologies filtration is married to a mixed-brand HVAC setup that requires cross-manufacturer knowledge to clean without disrupting airflow balance.
Every job carries the 365-Day Done Right Promise in writing, not as a verbal assurance. Every technician is background-checked and uniformed under Haven Standard Clause 3: Verified Crews. And every customer gets the photo record - we show the photo first, then talk about what needs to happen next.
FAQs
No - independent air duct cleaning does not void Abatement Technologies equipment warranties, provided the work is performed without altering factory electrical or mechanical components. We document our scope in writing to protect your warranty status. Call (737) 243-9544 if you need a copy of our standard scope language for your records.
OEM filters are specified for exact MERV rating and frame tolerance; some aftermarket equivalents meet these specs at lower cost, but others create bypass gaps or excessive static pressure. We source to manufacturer tolerance and note the origin on your job record. For HEPA-CARE and PAS systems, we typically recommend OEM given the tight seal requirements. We put the specific recommendation in writing before you approve the work.
You receive a Documented Photo Record of every duct run, before and after, as a standard deliverable - not as an extra charge. The images are timestamped and show the interior surface condition at each stage. This practice has been standard on every CleanRun job since 2013. If a company won’t show you the inside of your own ducts, you’re paying for vacuum noise.
Constant runtime usually indicates high particulate load or undersizing for the space, not necessarily duct contamination. We measure static pressure and compare to Abatement Technologies specifications for your model; if the ducts are clear and the unit still runs continuously, the issue may be unit capacity or envelope leakage. We separate duct issues from equipment issues in our written scope so you don’t pay for cleaning that won’t solve the problem.
Most Austin homes with Abatement Technologies filtration benefit from cleaning every 3-5 years, but caliche dust, recent construction, or pollen-heavy years (2021-2023 were particularly heavy for cedar and oak in Central Texas) can compress that interval. We inspect with a camera and tell you whether cleaning is actually needed rather than selling on a calendar schedule. Call (737) 243-9544 for a no-charge assessment.
Written by Tomas Reyes, Owner & Lead Technician, CleanRun Air Duct Cleaning Austin at CleanRun Air Duct Cleaning Austin, serving Austin and nearby areas.